It is hard to imagine, have a garage door without an automatic opener. Many people, however, begin each day with manual unlocking, opening and resealing your garage door by hand. Installing a garage door opener is not a difficult process, but you can add a second set of hands for some of the steps need to. If you are a veteran DIY kind of person, you should be able to handle you install your own garage door> Opener in a few hours. Follow these steps, and the opening and closing your garage door is as easy as pushing a button.
No matter what you choose to install the kit, it should come with the same essential parts. Start with the alignment of T-bars, so they created in the correct order. Many of the top brands of garage door openers are arrows at the T-rails, so they should be ok to feed a child's game. Then you want to bolt togetherthey are all one piece. You want to then take over the role and place it where it belongs in relation to the T-rails, and to ensure that the village as well.
You want to find the car unit and slide it on the rails. When the carriage unit is set up, you can go ahead and finish bolting the rails on the opener unit that came with your kit. This next step may be a bit complicated. You want to use a screwdriver and push it through one of the holes in the rails to keep the tramat the same place. Start fasten the belt or the chain to the car with the tools that came with your kit. You want the chain or belt around the roller and then wrap around the sprockets on the open unit. You should use this step when you finish the chain to the other side of the car unit.
The next part requires some measure. Open your garage door to the highest possible point and measure it. Add on about 2 to 3 inches and mark it on yourWall. Next is the center of the door and another mark on the wall. This is the place where you want to install the header bracket. You may need to use a 2 by 4, if there are no wall studs are held at this point.
Then take the role of the end of the assembly and attach it to the bracket above the door. Do not use a ladder to raise the entire assembly near the tracks of the door. Now take care of opening the door and lift your garage door NC so there are 2 cm above the open door. Use shims here.
Use lag screws to mount the molding attached to the ceiling of your garage. Bring your garage door opener unit on the bracket. At this point, you install the garage door controls and electric eye censors. Finish by pressing the clamps on the door. Before you know it, you have to be completely finished and the opening and closing your> Garage door with ease.
0 ความคิดเห็น:
แสดงความคิดเห็น